Century City · fault guide
Air conditioning running but not cooling in Century City
The unit is on, air is moving, and the room never gets there. Most of these calls are airflow, capacity or siting rather than a loss of gas.
A system that runs all day without reaching set point is working far harder than it should. The first distinction to make is whether the air leaving the unit is genuinely cold or merely moving.
If the air is cool but weak, the problem is airflow. If the air is not cold at all, the fault sits in the refrigeration circuit or the controls.
What usually causes it
Blocked filters and a dirty evaporator coil
The most common cause by a wide margin, especially close to the coast where grit and salt film collect quickly. Restricted airflow drops capacity and can freeze the coil.
Undersized capacity for the glazing
A unit chosen on floor area will lose against west-facing glass and an uninsulated roof. This is a specification problem, and no repair will fix it.
Low refrigerant from a slow leak
Coastal installations corrode at joints and flares. A recharge without finding the leak is a temporary fix that hides a growing problem.
Outdoor unit overheating
Units boxed into a courtyard, an enclosed balcony or a shared service recess cannot reject heat. The compressor throttles or cuts out on protection.
Sensor or control fault
A faulty room sensor reads the space as colder than it is, so the system satisfies early and the room drifts warm while the display looks normal.
Local conditions
How this shows up in Century City
Inland of the beachfront but still marine. Salt is lower than on the coast, yet basement plant rooms and roof enclosures reach high ambient temperatures, canal-side humidity is constant, and kitchen heat loads are far higher than the building's design assumptions.
- Condensers in basement or enclosed service areas recirculating their own hot air
- Body corporate approval needed before any outdoor unit position changes
- Restaurant grease coating condensers and cutting ice machine output
- Office HVAC with poor zoning, so a single floor runs the whole system
- Tenant and landlord equipment responsibility disputes when something fails
Checks you can do safely
- Confirm the mode is cooling and the set point is at least five degrees below room temperature.
- Rinse the indoor filters if they are visibly dusty.
- Check that the outdoor unit has clear airflow and is not enclosed.
- Look for ice on the indoor coil or pipework, which points to airflow or refrigerant.
If the filters are clean, the unit has clear airflow and the room still will not cool, the fault needs instrumentation: pressures, current draw, sensor readings and airflow. Book a diagnostic visit rather than adding gas blindly.
Questions we are asked
Where this work sits
Air Conditioning in Century CityNext step
Air conditioning running but not cooling in Century City
Send the details and we will come back with the next step. For anything urgent, call or WhatsApp and describe the fault: we will tell you what to do before we arrive.
What helps: the make of the equipment, what it is doing (or not doing), how long it has been like that, and whether the property is occupied.
Where we work: Milnerton, Century City & Royal Ascot. We do not cover suburbs assigned to other Reyds teams, so the local detail on this site stays accurate.
Milnerton source tag applied to every enquiry
Direct contact
Prefer to speak now?
Monday to Friday, 07:30 to 17:00, and Saturday mornings by arrangement. Emergency refrigeration work is taken by phone and attended as soon as the schedule allows.