What a heat pump actually does
It extracts heat from the outdoor air and transfers it to the water. That is why it uses less electricity than an element, and why its output drops as air temperature falls.
A unit rated at a comfortable ambient figure will not deliver the same output on a cold, wet Cape morning. Honest sizing uses the conditions the property actually experiences.
Size on demand, not tank volume
The question is how much hot water the household uses and when. Four people showering within an hour is a different duty from the same four spread across a day.
A unit sized on tank volume alone will either run constantly or rely on the element through winter. Neither is what the buyer expected.
Siting decides efficiency and neighbour relations
The unit needs a good volume of air and must not draw back its own discharge. Plant alcoves, under-deck positions and tight boundary corners all reduce output.
Noise matters. Against a boundary wall or below a bedroom window is a poor choice, and anti-vibration mounting only solves part of the problem.
Winter performance and defrost
In cold, humid conditions the outdoor coil frosts and the unit defrosts itself periodically. That is normal. Ice that does not clear points to a sensor, fan or airflow fault.
Efficiency falls in winter, which is exactly when hot water demand peaks. A correctly sized system copes; a marginal one is exposed.
Maintenance that actually matters
Clean the coil, clear the condensate path, check electrical terminations and verify the set point. Where the tank has an anode, inspect it.
A neglected heat pump still runs, but it runs longer, and that erodes the saving that justified it.
In short
- Size on hot water demand, not tank volume
- Site for airflow, noise and condensate drainage
- Expect lower output and defrost cycles in winter
- Keep the element as backup, not as the main heater
- Service annually and measure performance