Century City · technical guide · 7 min read
Specifying air conditioning for a Milnerton home — Century City
Why floor-area sizing fails in coastal Cape homes, and the five decisions that determine whether a system performs for a decade or struggles from the first summer.
Start with the building, not the room size
A rule-of-thumb kilowatt figure per square metre is a starting point for an office, not for a living room with four metres of west-facing glass. Heat arrives through glazing, through a roof that has been in the sun all day, and through the fabric of the building.
In Milnerton the dominant load is usually late-afternoon solar gain rather than midday air temperature. A west-facing living room and an east-facing bedroom in the same house are different problems, and they need different capacity at different times.
Choose the indoor unit around the architecture
Wall splits are the cheapest and simplest, and on a plain wall they are perfectly good. In a glazed living area they are visually intrusive, and the airflow can be unpleasant if the only available wall is behind the sofa.
Cassettes distribute in several directions and suit open-plan rooms. Ducted systems disappear entirely but need void space, access and a design that gets air to the right places. The most expensive mistake we see is choosing the indoor unit before checking where the pipe route and drain can run.
Site the outdoor unit for salt and airflow
Outdoor units reject heat into air. A unit boxed into a courtyard or mounted on a sea-facing wall fights both its own discharge air and corrosion, and it will fail early.
Brackets matter as much as the machine. Galvanised steel near the coast rusts through, and a falling condenser is dangerous. Where a coastal position is unavoidable, coated coils and a rinse routine are what buy the extra years.
Decide about zoning before installation
A multi-split or ducted system with zoning lets you condition bedrooms at night and living areas in the afternoon without running the whole house. On a large property that is the difference between a reasonable electricity bill and an unpleasant one.
Zoning has to be designed in. Retrofitting dampers and controls into a single-zone system is possible but rarely elegant, and often not worth it.
Plan for servicing from day one
Filters need cleaning, drains need checking, coils need rinsing. If the outdoor unit is behind a built-in planter or the indoor unit is above a locked bulkhead, servicing becomes a project.
Ask at design stage how someone will reach everything. It is the cheapest question in the process and the one most often skipped.
Local conditions
Applying this in Century City
Inland of the beachfront but still marine. Salt is lower than on the coast, yet basement plant rooms and roof enclosures reach high ambient temperatures, canal-side humidity is constant, and kitchen heat loads are far higher than the building's design assumptions.
- Condensers in basement or enclosed service areas recirculating their own hot air
- Body corporate approval needed before any outdoor unit position changes
- Restaurant grease coating condensers and cutting ice machine output
- Office HVAC with poor zoning, so a single floor runs the whole system
- Tenant and landlord equipment responsibility disputes when something fails
In short
- Size for glazing, orientation and use, not floor area alone
- Choose the indoor unit after checking pipe and drain routes
- Protect outdoor equipment from spray and give it real airflow
- Design zoning in rather than adding it later
- Make sure every unit can be reached for servicing
Fault guides referenced
Next step
Questions about Century City?
Send the details and we will come back with the next step. For anything urgent, call or WhatsApp and describe the fault: we will tell you what to do before we arrive.
What helps: the make of the equipment, what it is doing (or not doing), how long it has been like that, and whether the property is occupied.
Where we work: Milnerton, Century City & Royal Ascot. We do not cover suburbs assigned to other Reyds teams, so the local detail on this site stays accurate.
Milnerton source tag applied to every enquiry
Direct contact
Prefer to speak now?
Monday to Friday, 07:30 to 17:00, and Saturday mornings by arrangement. Emergency refrigeration work is taken by phone and attended as soon as the schedule allows.